CPS Controller

WHY CHOOSE BE ATEX

Re-calibrate of gas detection equipments
Check and verify of all PPE equipements
Customised configuration of all devices

The oldham CPS is a digital car park system that can handle up to 256 measurement points.

The Car Park System (CPS) is a detection solution for parking facilities, available for all types of vehicle, including petrol, diesel, LPG, biofuel and electrical.

With the capacity for up to 256 measurement points, in addition to ventilation management architecture, the CPS is a comprehensive solution in terms of both ventilation and ease of use.

The system can deal with most issues, including in large parking facilities. Cabling architecture is optimised as the system makes it possible to connect different types of detector, such as CO, NOx, hydrogen or LPG, to the same bus.

Modules available:

Sensor module CPS 10
Relay module CPS RM4 or CPS RM8
Logic input modules CPS DI16
Analogue output modules CPS A04

See video

Characteristics

Size

12.6 x 7.1 x 3.7 in. (32 x 18 x 9.5 cm)

Operating temperature

+14°F to +104°F (-10°C to +40°C)

Humidity

5-95% RH, non condensing

Power supply

85 to 264 VAC

Consumption

1.5 A (115 VAC) / 0.8 A (230 VAC)

Protection Class

IP54 (central detection controller) - IP31 (rack)

Approval

Low Voltage Directive: This device is in compliance with the security requirements of Directive 2014/35/EU based on standard 61010-1 and its second amendment
Metrology: Underground parking facilities: according to VDI 2053
EMC Electromagnetic compatibility: According to EN 50270 ETL approval for US & Canada
NTRL Approval
In compliance with ANSI/UL 61010-1-2005 and in compliance with
CAN/CSA-C22.2 No. 61010-1

Warranty

2 years

Additional feature

Internal back-up battery: Optional, 600 mA/h capacity

Features

INPUT SPECIFICATIONS

Available lines: eight digital lines of 32 modules
Type of cable: two shielded twisted pairs RS-485
Module power supply: 12 to 30V DC delivered by the system
Digital module network: RS-485 Modbus, 1 to 32 addresses selected with mini switches
Insulation: 1,500 V between the power supply and the digital network

ALARMS

Relays: three local internal relays: R1 (alarm/fault), R2 (alarm) and R3 (alarm)
RCT contact on each relay:
2A/250V AC - 30V DC (resistive charge)
Alarms per channel: six per sensor (alarm one to four, out of range and fault)
Programming: for instantaneous or averaged values, by increasing or decreasing values, and manual or automatic rearming

Datasheet

CPS datasheet - BE ATEX

Manual

CPS - User manual

Accessories

Back-up Power supply

CPS Controller

Restricted HTML